Aquapac Waterproof Radio Microphone Case, Small

Inner Case Quantity: 1 Master Case Quantity: 1 What’s so special about this case? This case is designed for electronics which require a thin wire to be connected to them at all times. The special wire-thru clamp at one end allows that wire to stay connected, and be waterproof. The case is usually used by professionals with specialist electronic devices. Suits mini radio mics from brands such as Audio Ltd and Audio Engineering Micron. Key Features Use all buttons and switches through the case Also protects from dust, dirt and sand Supplied with a belt, or you can use your own belt Like most Aquapac cases, it’ll float if you drop it in the drink Seals around a wire of up to 1/10th in / 3.5mm diameter The seams are high-frequency welded to form a super-strong bond. This case features our ‘TC’ Aquaclip which makes the case waterproof to IPX6. Temporary immersion is fine, but not continuous immersion. Important Notes Cases with this clamp are for surface use only, but will offer protection from temporary submersion. They are not recommended for prolonged immersion. When not using the case leave the TC clamp open. If not the wire or tube could eventually cause a permanent distortion of the foam, risking leakage. As long as you follow this instruction the clamp will be watertight with or without a wire/tube. The maximum thickness of wire/tube around which the TC clamp will seal is 1/10th inch (3.5mm). Warning: Aquapac's warranty covers the Aquapac only, and not any items that may be put inside it.