Ozonator for Single-Pump Hot Tubs

Hook this up to your single-pump hot tub and enjoy soothing warm water with fewer chemicals. See installation instructions below. What is an ozonator?

Power: 110-120 volt Connector type: J&J connector Cornona discharge This ozonator works with the following hot tubs: Weider Cross-Over Weider Legacy Weider Legend Image 615 Image 616 Image 716 Weslo Daybreak Use Less Chemicals With an Ozonator! This Ozonator sanitizes your hot tub water. This means you don't have to constantly use chemicals like chlorine. Ozone water purification is up to 3,000 times more powerful than ordinary water sanitizers and doesn't have that "chemical smell" normally found in pools and hot tubs. An ozonated hot tub will also last longer between water changes. Wondering how it works? It's simple. Ozonators create ozone gas, then inject it into the water, killing bacteria. Ozonator installation: 1. Locate or install a dedicated spa jet. 2. Tee off the water return line to the dedicated spa jet. (Tee off after the heater and before the filter or after the filter) on a suction filter spa, tee off after the heater. 3. Plug the other side of the water side of the jet. 4. Install the brass barbed adapter to the air fitting on the dedicated jet, plug the other side, then install approximately 6-inch black ozone supply tubing to the barbed adapter and add the ozone check valve in an upright position in order that the air can go to the spa. 5. Connect the ozone supply tubing check valve and install a double loop above the water line. 6. Install the Ozonator, preferably in an upright position. 7. Start up the spa and make sure the supply tubing is sucking air, then connect the supply to the Ozonator.