Monoprice Select ABS Plus+ Premium 3D Filament 1kg 1.75mm - Black - Compatible With Almost All 3D Printers And 3D Pens

Get outstanding 3D printing results when you use 1.75mm ABS Plus+ 3D Printer Filament from Monoprice! ABS Plus+ is an upgrade of ordinary ABS filament, which is one of the most commonly used filament types in 3D printing. It is 40% stronger than ordinary ABS filament and has good overall toughness. This 1.0kg spool features a thickness of 1.75mm ?0.10mm, with a roundness variation of only 0.05mm. It has a nominal processing temperature of 210 ~ 240°C (410 ~ 464°F). Thickness and roundness factors are laser measured at the factory to ensure accuracy over the entire length of the filament. The negatives of using ABS Plus+ is that it can give off a white smoke with a concentrated odor. It is best to ensure that the printing room is well ventilated when using ABS. Additionally, it has a high moisture absorption rate. Depending on the overall humidity level of the printing environment, an opened spool can absorb enough moisture after a couple of days that high temperature printing could cause bubbles or pocks in the extrusion. It is therefore recommended to not open a spool until you are ready to print and to store any unused portion with silca gel and/or an active dehumidifier to reduce the amount of moisture it can absorb.

Buy with Confidence: With Monoprice's Lifetime Warranty on all Cables, you can rest assured we stand behind our products and our customers. ABS Plus+ is an Upgrade of ordinary ABS filament, which is one of the most commonly used filament types in 3D printing. It is 40 percent stronger than ordinary ABS filament and has good overall toughness. Has a high moisture absorption rate. Spindle Diameter: 54mm (2.1 inch). Reel Width: 66mm (2.1 inch).