Battic Door 22 in. x 54 in. Better Attic Stair Cover

Battic Door Better Attic Stair Cover is an energy-efficient pull down ladder insulating cover. New codes require the attic access to be insulated to the same level as the attic. The kit includes everything you need to cover and seal your pull down ladder. The kit includes the rigid box (Stair cover), rubber gasket, and reflective shield. Add your own desired amount of insulation into the pocket above box. Installs easily without tools. Insert the insulation (Not included) into the reflective shield, and place the stair cover rigid box into the reflective shield covering the insulation. The shield holds the insulation to the box. Additional insulation (Not included) may be added to the sides, or insulate the attic up to the sides of the stair cover kit. The stair cover fits between trusses. Available in 3 sizes to fit most any size or brand of pull down ladder: 22 in. x 54 in., 25 in. x 54 in. and 30 in. x 54 in. Also available with R-50 insulation.

. New codes require the attic access pull down ladder be insulated to the same level as the attic floor (Minimum R-30), unless insulated to a minimum of R-30, attic ladders do not meet code . Kit includes a stair cover box sized to fit perfectly onto the frame of your wood or aluminum pull down ladder . Stair cover kit weighs about 10 lbs. (When insulated) and rests on a rubber gasket to provide an air seal . Stair cover box is covered with reflective aluminum foil wrap that reflects attic heat and creates a large pocket over the box that is filled with your fiberglass insulation (Not included) . Additional insulation (Not included) may be added to the sides of the box (Space permitting), or insulate the attic up the sides of the stair cover kit . Durable stair cover box is made of white heavy duty corrugated board, ends are 3 layers thick for strength and durability . Easy to install - the kit assembles in minutes without tools . Add your own desired amount of fiberglass or other insulation into pocket on top of the stair cover box . Stair cover box is 13 in. deep and fits most any brand of wood or aluminum 22 in. x 54 in. size attic stairs . Interior dimensions of box are 21 in. x 52 in. . How to measure: Measure the hinged plywood door, if 21 in. W x 52 in. L this is the correct kit, other size kits are available for other size stairs, measure and buy the correct size - bigger kits will not fit smaller stairs . Stair cover will rest on the 3/4 in. W frame of the ladder, not on the top of joists or attic floor . To enter attic climb ladder and push stair cover out of the way, the stair cover is not connected or hinged, when leaving attic lower box back into position, ladder folds up inside of box