JBL CSMA280 Commercial/Restaurant 2 x 80w Amplifier+Black Wall Volume Controller

Package Includes: (1) JBL CSMA280 Commercial/Restaurant 2 x 80w Amplifier 4ohm/8ohm/70V/100V, 8 inputs(1) JBL CSR-V Black Wall Volume Controller For Select CSM/CSMA/VMA Mixer Amplifiers Description of CSMA280: Designed for commercial and industrial use, the CSMA 280 Commercial Series Mixer/Amplifier from JBL is a mixer/amplifier with eight mixer-channel inputs and two output channels. It's capable of reaching 80W of peak power with 10W per channel. The unit's front panel sports volume controls for each channel, as well as two master volume adjustment knobs, two sets of bass and treble controls, and a power switch. The volume controls are illuminated so they can be seen and operated in darkened environments. Specifications of CSMA280: Maximum Output Power: 800 W per channel into 4 Ohms or 8 Ohms, 1 kHz, = 0.5% THD Insertion Loss: 1 dB maximum for 70 and 100 V outputs Continuous Power: 10 W per channel Line Output Level: 5.0 V RMS into 10 kOhms Input Sensitivity: To obtain full rated power at 8 Ohms (or 5 VRMS to line output). Mic Input: 3 mV RMS. Line Input: 775 mV RMS. RCA Input: 300 mV RMS Number of Channels: Input: 8, Output: 2. Frequency Response: Measured at 2.83 V RMS into rated load impedance at any output. 4/8 Ohms Output: 20 Hz - 20 kHz, ±2 dB. 70 V/100 V Outputs: 80 Hz - 15 kHz ±2 dB. Line Out: 20 Hz - 20 kHz, ±1 dB Total Harmonic Distortion (THD): Measured at 2.83 V RMS into rated load impedance at any output. Power Amplifier Output: <0.5%, 20 Hz to 20 kHz. Line Output: 0.05% typical Signal to Noise Ratio: > 90 dB Nominal Input Impedance: Mic: 400 Ohms. Line: 20 kOhms (balanced). RCA: 50 kOhms. Minimum Load Impedance: Low Impedance Output: 4 Ohms. 70 V Output: 120 Ohms. 100 V Output: 240 Ohms. Crosstalk: -70 dB @ 1 kHz Controls: Front Panel:8 x Input level rotary knobs2 x Output volume-attenuating knobs1 x Power switch2 x Bass potentiometers2 x Treble potentiometersRear Panel:2 x Input-routing dip switches (including phantom and Hi-Z switches)8 x Mic/Line selector switch2 x Vox adjustment switchesIndicators:Front Panel:8 x Input signal presence ring, green2 x Output volume ring, green1 x Power switch ring, green/blueConnectors:Rear Panel:1 x IEC power input2 x Aux out connection points6 x 3-pin euroblock connectors6 x 3-pin euroblock connectors2 x 5-pin euroblock connectors6 x Dual RCA input connectors2 x RJ45, remote volumeOperating Temperature / Humidity: 32 to 95°F / 0 to 35°C, 95% RH (non-condensing)Storage Temperature: -4 to 185°F / -20 to 85°CPhantom Power: 27 VDCAC Input: 100-240 VAC, 50/60 HzDimensions (W x D x H): 17.2 x 11.9 x 1.7"" / 436.9 x 302.3 x 43.2 mmWeight: Approximately 11.9 lb / 5.4 kg Description of CSR-V-BLK: The JBL Commercial® CSR series remotecontrols allow analog DC voltage toprovide logic control ranging from source selection and volume. Wired with Cat 5cable with universally accepted RJ-45 connectors up to 1000 feet (305 m) length,the CSR series remote controls allow you to remotely select the source and/orcontrol the volume on the CSM mixer. Using the CSR-V remote control with your CSMmixer, you can remotely control the volume of the source selected by the mixer. Features: JBL CSR-V Black Wall Volume Controll

Package Includes: (1) JBL CSMA280 Commercial/Restaurant 2 x 80w Amplifier 4ohm/8ohm/70V/100V, 8 inputs. (1) JBL CSR-V Black Wall Volume Controller For Select CSM/CSMA/VMA Mixer Amplifiers. Features: JBL CSMA280 Commercial/Restaurant 2 x 80w Amplifier 4ohm/8ohm/70V/100V and 8 inputs. For Commercial and Industrial Use. 80W into 8 or 4 Ohm Loads. 10W Per Channel. 8 Input Channels, 2 Output Channel. Usable with 70 & 100V Systems. Euroblock Mic/Line & RCA Inputs. Hi-Z & 27V Phantom Power Switches Sleep Mode & 2 Auxiliary Outputs. Voice Activated Ducking & Priority Mute. Specifications: Maximum Output Power: 800 W per channel into 4 Ohms or 8 Ohms, 1 kHz, ? 0.5% THD. Insertion Loss:1 dB maximum for 70 and 100 V outputs. Continuous Power: 10 W per channel. Line Output Level: 5.0 V RMS into 10 kOhms. Input Sensitivity: To obtain full rated power at 8 Ohms (or 5 VRMS to line output). Mic Input: 3 mV RMS. Line Input: 775 mV RMS. RCA Input: 300 mV RMS Number of Channels: Input: 8, Output: 2.. Frequency Response: Measured at 2.83 V RMS into rated load impedance at any output. 4/8 Ohms Output: 20 Hz - 20 kHz, 2 dB. 70 V/100 V Outputs: 80 Hz - 15 kHz 2 dB. Line Out: 20 Hz - 20 kHz, 1 dB. Total Harmonic Distortion (THD): Measured at 2.83 V RMS into rated load impedance at any output. Power Amplifier Output: <0.5%, 20 Hz to 20 kHz. Line Output: 0.05% typical. Signal to Noise Ratio: > 90 dB Nominal Input Impedance: Mic: 400 Ohms. Line: 20 kOhms (balanced). RCA: 50 kOhms.. Minimum Load Impedance: Low Impedance Output: 4 Ohms. 70 V Output: 120 Ohms. 100 V Output: 240 Ohms.. Crosstalk: -70 dB @ 1 kHz. Controls: Front Panel: 8 x Input level rotary knobs. 2 x Output volume-attenuating knobs. 1 x Power switch. 2 x Bass potentiometers. 2 x Treble potentiometers. Rear Panel: 2 x Input-routing dip switches (including phantom and Hi-Z switches). 8 x Mic/Line selector switch 2 x Vox adjustment switches. Indicators: Front Panel: 8 x Input signal presence ring, green. 2 x Output volume ring, green. 1 x Power switch ring, green/blue. Connectors: Rear Panel: 1 x IEC power input. 2 x Aux out connection points. 6 x 3-pin euroblock connectors. 6 x 3-pin euroblock connectors. 2 x 5-pin euroblock connectors. 6 x Dual RCA input connectors. 2 x RJ45, remote volume. Operating Temperature / Humidity: 32 to 95F / 0 to 35C, 95% RH (non-condensing)