JEGS 159010 HP Electric Fuel Pump -08 AN Inlet -06 AN Outlet Flow Rate: 104 GPH

HP Electric Fuel Pump -8 AN Inlet -6 AN Outlet Flow Rates: 104 GPH (310 LPH) @ 7 psi 75 GPH (283 LPH) @ 40 psi 63 GPH (240 LPH) @ 58 psi JEGS 555-159010 HP Electric Fuel Pump Features: Maximum recommended operating pressure: 65 psi continuous, 90 psi intermittent Supports carbureted gasoline engines up to approximately 900 hp normally aspirated and 700 hp turbo/supercharged Compatible with EFI gasoline engines up to approximately 700 hp normally aspirated and 500 hp turbo/supercharged For use with either carbureted or fuel-injected gasoline engines This fuel pump utilizes port-style O-ring fittings; -8 AN inlet and -6 AN outlet. DO NOT use pipe thread or thread sealant with these fittings. Includes brass stud terminals (for quick and reliable electrical connection) with boots and two t-bar style mounting clamps Pump dimensions: length 7 3/4 in., diameter: 2 1/2 in., base to top of mounting bracket: 3 3/4 in. JEGS 555-159010 HP Electric Fuel Pump Rating Formulas: All GPH Ratings Measured at 13.5 Volts LPH = (GPH x 3.785) GPH = (LPH / 3.785) PSI = (Fuel Rail Pressure + Boost Pressure) JEGS 555-159010 HP Electric Fuel Pump Rating Notes: A high-capacity fuel �pre-filter� with either a 40 micron, to no greater than 100 micron rated element should be installed in the fuel line between the tank and the fuel pump inlet. A by-pass or return style fuel pressure regulator MUST be used with this fuel pump. You can gravity feed this pump by mounting it as low and as close as possible to the fuel tank. The installation of either a rear mount reservoir style sump or a high flow capacity fuel tank pickup in your stock tank is highly recommended. These will ensure that the fuel pump is able to self-prime and avoid pump starvation and cavitation. Failure to follow these recommendations will result in poor fuel system performance and drastically shorten the fuel pump's life. Click Here for help on Fuel Pump Sizing! N A

SUPPORTS carbureted gasoline engines up to approximately 900 HP normally aspirated and 700 HP turbo/supercharged COMPATIBLE WITH EFI gasoline engines up to approximately 700 HP normally aspirated and 500 HP turbo/supercharged FOR USE WITH either carbureted or fuel injected gasoline engines INCLUDES brass stud terminals (for quick and reliable electrical connection) with boots and two T-bar style mounting clamps PUMP DIMENSIONS: length 7-3/4", diameter: 2-1/2", base to top of mounting bracket: 3-3/4"