StewMac Neck Shims for Bass, Blank, 0.50 degree - 6-pack

SAVE WHEN YOU BUY A 6 PACK! Tapered maple shims used to change the angle of a bolt-on neck. To change the angle of a bolt-on neck, players and repair shops have used shims for years. We've seen everything from matchbook covers to guitar picks stuck in neck joints. Those kinds of shims create an unwanted gap under the heel of the neck: a dead air space where humidity condenses to swell the wood. As Dan Erlewine describes in his Guitar Player Repair Guide: "This gap may cause an upward kink in the neck. And many players feel they lose tone unless firm contact is maintained between the neck and the body." Dan creates tapered shims that cover the entire heel of the neck. With these ready-made shims, that work is done for you. Attention repair shops: Making a quality shim takes time. Keep these on hand for a quick turnaround on this common repair. These blank shims are designed for odd screw spacings, smaller neck pockets, and custom designs like the Fender Micro-Tilt™. They offer full contact and are precisely tapered. This set includes 6 (six) 0.5-degree hard maple shims. You'll reach for shims of this size taper most often because they work great on Fender and many other solidbody guitars. Dimensions: 2-3/4" x 3-7/8" (69.86mm x 98.43mm) Taper specs (approximate): 0.5-degree shims taper from 0.028" to 0.008" (0.71mm to .020mm)

Used to change the angle of a bolt-on bass neck Made of solid maple to match the guitar neck Better than the typical homemade "guitar pick" neck joint shims, which create an unwanted gap, these tapered shims cover the entire heel of the neck Keep these on hand for a quick turnaround on this common repair Set includes 6 (six) 0.5-degree hard maple shims; this taper works great on Fender and many other solidbodies